Got it set up and printed a little trinket I’d made for my wife earlier, that on the CR-10 printed in about 27 minutes; took a flat 13 on the K1 and that was with a very conservative 7500 mm/min. I’m excited to see what this can push up to!
Ah, yes - the Cartesian to CoreXY swap. At a certain point you might want to consider a bigger nozzle. Yeah, physically moving faster is nice, but being able to go from say 4 walls to 2, while keeping the same wall thickness and without a time hit, is great.
Got it set up and printed a little trinket I’d made for my wife earlier, that on the CR-10 printed in about 27 minutes; took a flat 13 on the K1 and that was with a very conservative 7500 mm/min. I’m excited to see what this can push up to!
Ah, yes - the Cartesian to CoreXY swap. At a certain point you might want to consider a bigger nozzle. Yeah, physically moving faster is nice, but being able to go from say 4 walls to 2, while keeping the same wall thickness and without a time hit, is great.