Hey,

Still fairly new to this hobby and have lots of ideas but I’ve got a snag with a few prints now and was hoping someone could help me work out what I’m doing wrong.

The project is small trays for a custom advent calendar but as you can see the corner on the second picture has lifted massively.

A 3d printed tray in grey with a handle.

This has happened before with a different print too and I never solved that issue either.

Using an Ender 3 Pro with some generic filament from amazon, hot end at 200C (goes stringy any higher), bed was 50C for this print I think.

Any help would be wonderful :)

  • Krackalot@discuss.tchncs.deEnglish
    3·
    8 months ago

    I recommend using mineral spirits. It’s the only thing that has improved bed adhesion. WITH THE HEAT OFF! I don’t know that mineral spirit vapors are bad, but they’re definitely not good…