.05 on my ender 3 s1 sounds perfect based on the tolerance tests I’ve run. Thanks!
.05 on my ender 3 s1 sounds perfect based on the tolerance tests I’ve run. Thanks!
Thats a very fair point. I’ve done tolerance tests with mine and can get away with 0 with some encouragement and .05 just fine. Thanks!
Just curious, when making this how much tolerance did you account for? I want to make some for baseball teams, but wasn’t sure how much to add.
Shouldnt be the filament then. I would make sure the probe is fully secured like the other comment suggested. Good luck, that sounds frustrating! I need to adjust mine, but usually after printing for a couple weeks.
What type of material are you printing? Could be the material is eating away at the brass nozzle causing you to need to adjust the z offset.
Similar results with my Ender 3 S1. Highly recommend!
If you live near a Microcenter you can get it for even cheaper: https://www.microcenter.com/site/content/specialoffer3dprinter3i.aspx
This deal is not always limited to new customers. I bought a month or so ago on sale at this price and I shop there regularly.
Run the auto level on the printer. Once it finishes it will zero out where it thinks the z is. You can then adjust it down to the correct level. Too high, stuff won’t adhere to the plate. Too low, it squishes it. Just right, and you get the picture.
You can use a piece of paper as a guide or a feeler gauge if you have one.
I’d imagine the steps are very similar on the s1 pro.
I have the S1 (non pro version). I purchased it around a month ago and have been loving it! Sure, it requires a little bit of tinkering, but ultimately if I have the z-offset correct for the first layer, it prints great. I imagine there are quicker printers out there, and ones that have more features. But for an entry printer, I cant complain. If you have any questions, feel free to reach out!
I appreciate the tips - I printed using the same settings you used and it turned out great! Ill get it mounted to the wall later today.
You don’t even need a pi for this option. I’m running octoprint off an old android phone and it works great.
Thanks for sharing the files. I just found my skateboard from when I was younger and wanted a way to display it!
I had a similar issue when I initially installed Klipper on my Ender 3 S1 (not the plus). It would not connect unless I fully restarted Octoprint whenever I turned on the printer. The change I needed to make was go into settings in Octoprint (though I assume its similar on other front ends), and add the following settings:
Serial Port: /tmp/printer
Baud Rate: 11520
If that is not the case for you, try to add some more details. Do you have the config file correct?