Canada is also still under the monarchy so it’s not like we could side with America against the world
Canada is also still under the monarchy so it’s not like we could side with America against the world
I wouldn’t recommend water washable even though it’s cheaper not using IPA it’s more cumbersome and possibly expensive to dispose of it. You can just dump it down the drain
Yeah fdm is not always the best or the easiest to get successful prints with. It takes a lot of supports and patience. Also try dropping layer height to .12
Yeah print from bottom to top. That gives you the best resolution
I think thingiverse is like the Reddit of models and printables is like the Lemmy.
I recall there being some issue people had with thingiverse but it’s still where all the action is.
Yeah Id give away all my filament do whatever with it in the name of environmentalism but I’m not paying for a company to sell my off cuts
I would love for a small business to have one near me. I would literally give them the scraps for free. I’ve just been saving the chunks in a bin
Did you print him on his back with a 0.4 layer or what?
We can hope Putin dies from being an old fuck and Russia gives up
Put it next to your live laugh love poster
So you have to do all this instead of having 2 cardboard circles on the side of the spool. 2 recyclable circles
You mean your favourite post it
So is it just g29 L0 that I need to add? I suspect mine is not using the mesh either
Every stl started as someone’s custom print
Yeah I just played the early access for like 2 hours. It’s like dos2 but prettier and DnD themed now
4x10s sucks unless it comes with more breaks. 4 is what we want. Or 5 6s