The solution was more cooling. It was warping due to too much heat, I increased cooling to 100% and reduced overhang speed slightly and it now prints well.
The solution was more cooling. It was warping due to too much heat, I increased cooling to 100% and reduced overhang speed slightly and it now prints well.
Both ASA and ABS are approved materials. ASA has higher heat defection than ABS, should be easier to print and it smells significantly less when printing.
Fans are completely disabled, except for overhangs and bridges. If I disable fans for overhangs and bridges, they sag like crazy.
I doubt draft shield is going to do anything, the printer is already completely enclosed in a tent. I have around 50-55°C inside the tent.
Edit: I tried a re-print with less cooling for overhangs, it seems to exacerbate the issue significantly.
On top of that, the bZ4x is apparently a really shitty car. So on top of only having that one model, it’s also a terrible one.
Would this be a good entry level device?
Kind of impossible to say right now, it’s not released yet. On paper it seems like a good deal, almost too good at that price point. I wouldn’t buy one until I’ve seen some reviews.
Damn, that’s a crazy low price for a coreXY with a 42.000cm^3 build volume
I’m not sure how high the resolution is on resin printers, but the tip of a record stylus is maximum 0.001mm in diameter, here are the specs for records, it’s some pretty small grooves with very fine detail you need for something that’s passable.
That image is not mine, it’s just for reference by the other user to show me where to look
Nothing, and it just reports 100% packet loss when I terminate the ping command.
as far as i can tell from the output, i think my DNS is working?
this is the contents of the interfaces file
I don’t have anythiung seperated in to different VLANs, and i only use this single subnet. all other devices can ping outbound without issues.
No i haven’t split anything in to separate VLANs
192.168.68.210 is my adguard, it’s on a different machine. It should be working, all my other devices use it and I can see the traffic going through it. My servers IP is 192.168.68.120, and I can’t see traffic from that on my adguard at all. But it can ping my adguard.
It is set to my router IP
this is the output when i run curl httpS://google.com -vvv
this is the output of ip route.
192.168.68.1 is my router, 192.168.68.120 is the proxmox host
sure
Wow yeah that first one is pretty terrible looking 😅
I’m decently pleased with mine though, but I’m really looking forward to the quality on the voron. I actually already have “the filter” on my current printer (slightly oddly placed in the tent, but it works), and I just connected it directly to the printer PSU and manually turn it on/off with a toggle switch.