I’ve been using it on Ubuntu 22.04 for almost 2 years. It started off rocky, with frequent restarts needed, maybe every week or two. It’s been pretty solid, though I did give up on using it for screen sharing and captures, which is unfortunate timing in today’s WFH world.

You say that, but after my last set of tuning my E3 Pro is a real workhorse! Give it another 4 years like I did. May also help to threaten it with replacement if it fs up ONE MORE TIME…

You can have my fireworks when you pry them from my cold, dead fingers. Which are over there, near the fireworks.

Sure, I have no love of Meta either, which is why I would love for people to have an easy escape hatch via the Fediverse…

You probably aren’t wrong about it being overly idealistic and optimistic. :-(

That’s an interesting point, one of the reasons I chose lemmy.world was that it wasn’t ban-happy.

Since writing my comment above, I’ve come across Cory Doctrow’s “Let the Platforms Burn” article where he argues that interoperability and the ability for users to move to other platforms is the best way out of the Meta situation. https://doctorow.medium.com/let-the-platforms-burn-6fb3e6c0d980

(Apparently) Unpopular Opinion: I think defederating Threads is the wrong move, because it just locks people into Threads. If people on Twitter had the ability to move to Mastodon AND still interact with all the people they did before, I think we would have seen even more people move. The only reason I still check twitter at all is because I have a few close friends who didn’t move. Meta is likely going to have big adoption of people who aren’t ready to go to Mastodon, but are interested in getting out of the dumpster-on-fire that twitter seems to continue to be. But blocking those people from being able to join the more popular Lemmy instances, given no actual policy violations, just will keep people in Meta that otherwise could leave. With the “however” being: It’s not quite clear to me that Threads users will be interacting with Lemmy as much Mastodon, if Threads were a Reddit replacement, it’s more directly connected.

I live in Colorado which is pretty dry, so I don’t have too many problems with wet filament, or at least the problems I have are a much smaller vector than others seem to have. I always try to store my filament in a bag with the drying packet, but I usually don’t even really close it that well. But I’ll also just leave filament on my printer for weeks between uses. I always feel like some of the difficulties I have might go away if I was more fastidious about filament, but I seem to do good enough.

But, I’ve also done all sorts of upgrades to try to get more reliable, without really being good about keeping my filament happy. Upgrades: Sprite hotend, CRTouch, upgraded steppers (went through a bout of really bad layer shift I couldn’t track to anything else, and the steppers fixed it), Klipper, upgraded mobo.