It was a nail biter

How much purge for something like this?

There was a group that was great at it nearly 100 years ago, and even those guys couldn’t get it done in a few months. Properly genocoding a people doesn’t happen overnight. Isreal has just been oppressing until recently so the genocide thing is going to take a bit longer.

Hey this comment is getting reported for misinformation. Can you link please provide a source for this information?

The mod log is visible to everyone.

Is steam deck AMD? That would make a lot of sense.

What are you even trying to do with this comment?

I tried to buy another identical set of cutlery because we needed more and the two version while looking identical on the package and being from the same maker are dramatically different in reality and it makes me crazy.

I have a whole set that I HATE. I put them in backward so I don’t pick one up by accident.

Please also list the reasons for rejection. I am sure every one of these offerings were 100% reasonable and Palestine just loves being subjegated.

It was showing as middle of the road for the credibility rating, which on its own is shaky but with a corroborating report strengthens it.

Thank you. We were getting reports on it, and I didn’t want to remove it if it was a credible story.

Please provide corroborating story link from a credible source. I will have to remove if the story link can’t be updated to a more reputable source.

We will talk this over with the rest of the mods and make a decision.

Well this is just a bad take.

On my Prusa’s there is a pause command. The Artillery should be using Marlin (unless you flashed something else). Your slicer (Cura especially) will let you add a pause and even tell the machine where to park the head, that doesn’t use M600. I guess it depends on your firmware and the slicer you are using. It would easy to experiment with it. Put down a small test cube and add some pause commands and see what happens. I would use Cura or Prusa Slicer if you can as they both have pretty good support for the typical commands you would use on this.

When I make magnets on the printer. I create voids the shape of the magnet in the model near the bottom surface, then have the printer pause right before it the layer it is set to close the hole. Drop the magnets in and resume print. It will completely encase the magnet.

If you are up for suggestions. I would swap filaments at the layer after the base is finished and switch colors so that the logo will pop against the base color.

deleted by creator

A moderating news in these trying times is a tough job. Thank you guys.