It’s also the main component of some plastic model glues.

digital stuff is great!

Until they pull a 1984 and delete your copy of 1984

Personally I stopped using printables after they allowed proprietary designs.

Isn’t this like the fourth time this has been posted? the conversation always goes around in circles with nobody changing their mind.

I use brave search from firefox, seems the least shitty search engine so far.

Nothing against brave the browser, I’ve just been using firefox for about 10 years so have a lot of inertia.

https://termbrowser.nhs.uk/?perspective=full&conceptId1=23560001&edition=uk-edition&release=v20230802&server=https://termbrowser.nhs.uk/sct-browser-api/snomed&langRefset=999001261000000100,999000691000001104

This is the NHS term database.

edit: lemmy is breaking the link for some reason, lets try this

The official term in the UK is Asperger’s disorder, although I’ve never heard it actually called that.

My understanding is most 20mph zones are simply advisory, as they don’t have traffic orders.

I’m guessing it doesn’t stop them putting DRM in parts and making parts cost more than a new phone.

The navy doesn’t have that problem ;-)

It seems like it would be difficult to stop a defendant, having been physically forced into the dock, from disrupting proceedings.

Don’t they literally receive funding from the US government?

Vitamins is a reprap term for non 3d printed parts, screws, motors, etc.

From the instructions it looks like it uses pronterface https://raw.githubusercontent.com/nophead/Mendel90/master/dibond/manual/Mendel90_Dibond.pdf

To add, if it’s using the Melzi board that some used, then you should be able to load g-code onto it using the micro SD card slot. It will depend on the firmware if it can recognise modern gcode though. You may be able to compile a modern version of marlin for it too.

There’s some info about it here https://reprap.org/wiki/Mendel90

This is a very old printer, from the early days of reprap. From a practical standpoint you would get better results from the cheapest new ender i3, and it would be a lot easier.

If you want an interesting project though it should be entirely possible to get it working, and you’ll learn a lot from it. If it’s still using the original Sanguinololu controller board that will be your biggest issue, as I doubt a modern version of the marlin firmware will fit in a ATmega644P. Your best bet would be to replace the controller board with something modern, then you can use it as any modern 3d printer.

Mastodon is full of netsplits caused by instances de-federating at the whims of various local BOFH.

It’s very flat, it works well with PLA, and it’s what my ultimaker 2 came with.

Same with glass, I ruined a few with PETG.

Pencil necked desk jockeys act like pencil necked desk jockeys